Australian Monitor Audio Telex ATC5488 - Manual

ATC5488
Tone Generator Module
Installation Instructions
Thank you for choosing an Australian Monitor Installation Series ATC5488 tone generator module. The
ATC5488 generates four tones. These are Evacuation and Alert Tones, both to AS2220.1.2 (Australian)
standards, as well as a Bell Tone and a Pre Announce Chime. Installation into compatible Australian Monitor
Installation Series mixers or amplifiers is made simple by utilising a standard ‘end’ type connector plug, which
plugs into a receptacle inside the mixer or amplifier. Please follow these easy instructions for installation.
For installation into an IC30 amplifier:
For installation into an SA series amplifier:
NOTE:
Locate the empty 7 pin ‘end’ connector receptacle on the mixer PCB
to the left of the heat sink when looking from the front panel. Connect the module to this receptacle, ensuring
that the orange wire on the connector is at the right hand end of the connector receptacle.
Locate the empty 7 pin ‘end’ connector receptacle on the mixer
PCB between the Ch 6 pot and the bass pot. Connect the module to this receptacle, ensuring the orange wire on
the connector is at the right hand end of the connector receptacle when viewed from the front panel.
The ATC5488 module is supplied with double sided adhesive enabling the module to be permanently attached
to the chassis or under the lid of your mixer or amplifier. On selected mixers and amplifiers, spare screw
terminals on the rear panel allow the activation wires from the ATC5488 to be connected to the back panel for
easy external connection to switches or a timer.
Note that the trim pot located in position R10 on the ATC5488 module attenuates the level out of the
ATC5488 and works in an anti-clockwise fashion ie, turning it fully clockwise will completely attenuate the
signal output whilst turning it fully anti-clockwise will allow full signal though to the amplifier stage.
Connections
Connection to amplifier: Orange - Output
Black - Ground
Blue - Mute switch
Red - DC Supply (Min. 12VDC, Max. 18VDC)
Connections to activate tones: Black - Common
White - Evacuation tone
Yellow - Bell Tone
Purple - Alert Tone
Blue - Pre Announce Chime
Engineered by Audio Telex Communications Pty Ltd, Sydney, Australia
A.B.N. 78 001 345 482 Inc in NSW
For installation into a TX6000 or TX8000 mixer:
For installation into an AMC series amplifier :
Locate the empty 7 pin ‘end’ connector receptacle behind
the Ch 5 pot on the mixer PCB. Connect the module to this receptacle, ensuring that the orange wire on the
connector is at the right hand end of the connector receptacle when viewed from the front panel.
Locate the empty 7 pin ‘end’ connector receptacle in the
middle of the mixer PCB. Connect the module to this receptacle, ensuring that the orange wire on the connector
is at the right hand end of the connector receptacle when viewed from the front panel.
INSTALLATION SERIES
Australian Monitor
The installation of the ATC5488 involves access to the inside of the mixer or amplifier.
Installation should only be attempted by a qualified technician. Always turn off AC power and
remove the AC power cord before attempting to access the inside of any Australian Monitor
Installation Series mixer or amplifier.
INSTALLATION SERIES
Australian Monitor