Australian Monitor AMISLSC1 User Manual

Amislsc1 line splitter/combiner, Introduction, Description

Advertising
background image

AMISLSC1

Line Splitter/Combiner

Introduction


The Australian Monitor Installation Series LSC1 line splitter/combiner

produces 2 balanced XLR signals, (1 direct, 1 transformer isolated) from a
single balanced XLR line level input. The AMIS LSC1 provides a ground lift

switch to eliminate hum, & as part of the AMIS Contractor Tools range, the
AMIS LSC1 is an inexpensive splitter/combiner that has a multitude of uses
in a wide variety of installations.

Description

Input: This balanced XLR Line level input receives signal from a line

source.

Thru Output: This balanced XLR output is wired in parallel to the Input

& provides a balanced signal output.

Output: This XLR output provides a transformer isolated output of the

input signal feed.

GND Lift Switch: When this switch is in “ground” position pin1 of both

the input & the output are connected. When this switch is in “lift”
position these grounds are separated. This switch is used to
eliminate hum.

Specifications


Input

impedance:

6 K Ohms @ 1kHz

Output Impedance:

600 Ohm

Dimensions:

95mm x 73mm x 40mm

Max Input Level:

+22 dBu @ 1 kHz .007% THD

Frequency Response:

10Hz-50kHz


Note: Unbalanced sources should be wired Pin 2 Hot, Pin 3 Cold, with Pin 1
linked to Pin 3.

Advertising