APG Cash Drawer Series 4000 - Manual

APG
®
CASH DRAWER
SERIES 4000 CASH DRAWER
OPERATING & MAINTENANCE INSTRUCTIONS
GETTING STARTED
Prepare a location for the cash drawer. Recommendations for a suitable location include:
•
A sturdy, level surface no less than the size of the cash drawer;
•
Operating temperature from 20
° F to 100° F (-7° C to 37° C);
• Non-condensing relative humidity from 20% to 80%.
LOCK FUNCTIONS (If applicable)
Two keys are included with each cash drawer for the manual lock. The key lock provides
four functions: locked open, manual open, electrically on-line, and locked closed. See Figure
2. The key may be removed in the 12 o’clock (Electrically On-Line), 9 o’clock (Locked
Closed), or 3 o’clock (Locked Open) positions. To reduce the risk of damaging or breaking
the key, remove the key from the lock during normal operation.
Electrically
On-Line
Locked
Closed
Manual
Open
Locked
Open
Key Number
Ax
x
Figure 2
MEDIA STORAGE
The media storage area, located below the till, includes two media trays with
packaged bill dividers. The dividers may be re-positioned into the tray’s grooves to
better meet your needs.
PARTS AND ACCESSORIES
For cash drawer parts and accessories, contact your supplier or visit our website at
http://www.apgcd.com.
REMOVING THE INNER DRAWER: PRODUCT STARTING WITH JB** OR JD**
Figure 3
REPLACING THE INNER DRAWER
Mate the outer slides (mounted to the drawer) with the inner slides (mounted in the cash
drawer housing). Lift the drawer up until it stops, and begin to push the drawer into the cash
drawer housing. When the strike plate on the back of the drawer has cleared the stop plate in
the base, let the drawer rest in the horizontal position. Push the inner drawer to the fully
closed position. You should experience additional resistance as you close the drawer since the
ball bearings do not roll until the slides are fully engaged. When the inner drawer is fully
inserted, cycle it a few times to verify that the drawer opens and closes properly.
PREVENTATIVE MAINTENANCE
The cash drawer slides should be periodically cleaned and lubricated. Frequency is
dependent on use and the environment. Using a dry, lint free cloth, wipe out the old
grease and debris from the inner and outer slides. Do not use water or any type of
liquid cleaner. Using a clean applicator, apply a thin layer of lithium-based bearing
grease to the inner and outer slides. Cycle the slides several times to properly coat
the ball bearings and to spread the grease evenly.
CAUTION: Breaking coin rolls on the money till may cause the plastic to fracture.
M-823 Rev. A