APG Cash Drawer Vasario User Manual

Installation & maintenance, Vasario, Cash drawer

Advertising
background image

VASARIO

CASH DRAWER

INSTALLATION & MAINTENANCE

INSTRUCTIONS

This information applies to the Vasario

electrically operated cash drawer products.

GETTING STARTED
Prepare a location for the cash drawer. Recommendations for a suitable
location include:

A sturdy, level surface no less than the size of the cash drawer

Operating temperature from 40° F to 105° F (5° C to 40° C)

Operating, non-condensing relative humidity from 10% to 90%.

LOCK FUNCTIONS
Two keys are included with each cash drawer for the key lock. The key lock
provides four functions: locked closed/open, electrically on-line, and manually
open. See Figure 1. The key may be removed in the 12 o’clock
(Electrically On-Line), or 3 o’clock (Locked Closed/Open) positions. To
reduce the risk of damaging or breaking the key, avoid leaving it in the lock
during normal operation.

Figure 1

PARTS AND ACCESSORIES
Contact your supplier for parts and accessories for your cash drawer.

REMOVING THE DRAWER
Open the cash drawer and remove the plastic coin and bill tray. Grasp the
drawer by the sides of the front and lift the drawer up until it stops. Tip the
front of the drawer down and pull the drawer out at an inclined angle.
See Figure 2

Figure 2

Caution: Be careful not to damage the lock bar mounted on the bottom of the
drawer.

REPLACING THE DRAWER
With the drawer front tipped down at an inclined angle, insert the drawer into
the case about 2 inches. Lift the drawer up until it stops, and pull the drawer
out until it stops and drops into operating (horizontal) position.
See Figure 3. When the inner drawer is fully inserted, verify that the drawer
opens and closes properly.

PREVENTATIVE MAINTENANCE
Every six months the cash drawer slides should be cleaned and lubricated.
Using a dry, lint free cloth, wipe out the old grease, along with any
accumulated dirt or debris, from the tracks and on the wheels. Do not use
water or any type of liquid cleaner. After the old grease has been removed,
apply a thin layer of lithium bearing grease to the front and rear wheels.

CAUTION: Breaking coin rolls on the edge of the drawer front or
plastic cash tray may damage the drawer front or cause the plastic to
fracture.

V-23-E Rev -

Advertising