Rivera Primo 1116-0400 H4 LED REPLACEMENT BULB - Manual

1116-0401 & 1116-0400 H4 LED REPLACEMENT BULB
Features
• Integrated design
• Built in chip
• Silver-plating red copper LED stand
• Aluminum protective shield for heat
dissipation instead of the traditional fan
cooling system.
• Softer light than traditional halogen lamp
• Easy installation
Specifications
• Voltage: 12V-24V
• Waterproof: IP68
• Lifespan: Over 30,000 hours
• Material: Red copper & aluminum alloy
• Current: 1.5 (A)
• Lumen: 2,400
• Power: 20W.
12450 Whittier Blvd. Whittier Ca. 90602 (562)907-2600 Fax: (562)907-2606 riveraprimoinc.com
Rivera Primo’s ® HedLED™ H4 replacement LED bulb provides unmatched brightness and
stability. This energy saving and environmentally friendly LED replacement bulb uses an advanced
thermoelectric separation process to provide the best heat dissipation and prolong the service life.
Removal of OE
INSTRUCTIONS
1. The 1116-0401 Kit. 2. Pull out the headlamp housing.
3. Remove the OE connector from
halogen bulb.
4. Remove the clip while holding the
halogen bulb in place.
LED driver & harness
LED & cooling unit
Protective shield
Please note that these pictures are for reference only and may not accurately represent your headlight.
5. Remove the clip.
6. Remove the OE halogen bulb from
headlamp housing.
7. Twist & remove protective shield. 9. Replace clip to secure protective shield.
8 . Insert protective shield into headlamp
housing while lining up the 3 prongs with
the 3 corresponding slots.
Installation