Bell & Gossett IM194R03 Grinder Pumps, Single and Three Phase, 1-1⁄4″ Discharge - Manual

WARNING
Effective December 2005 (date code M05) there are important changes to single-phase
motors. They now have a built-in, on-winding overload. They also require different start
and run capacitors in the control panel than old motors. Please read the information on panel wiring
and capacitor changes that are required to operate a new pump on an old control panel.
Grinder Pumps
1Ø and 3Ø, 1¼" Discharge
INSTALLATION, OPERATION AND TROUBLESHOOTING MANUAL
INSTRUCTION MANUAL
IM194R03