Aqua Bath CP3636TD (Front Trench Drain) - Manual

CP3636TD Acrylic Pan - Transfer Shower Unit - ADA Compliant
05/04
 AQUA BATH COMPANY INC.921 Cherokee Ave.Nashville, TN 372071-800-232-2284Fax (615) 227-9446
 www.aquabath.com 
Acrylic Pan - Transfer Shower - ADA Compliant
• Model CP3636TD
• Acrylic pans designed for new build and renovations of
existing hospitals, nursing homes, rehabilitation centers,
hotels, motels, dormitories and residential applications.
• Meets ANSI A117.1, ADA Guidelines and other standards
for accessibility
• Acrylic one-piece molded construction simplifies installation
with a lightweight durable base.
• Inside dimensions: 36" W x 36" D x 4" H.
• 3/4" threshold height for top of slab installation.
• Patented integral molded in "Trench Drain System" to help
channel water to the front trench drain location located
approximately 4" inside of the front flange.
TRANSFER SHOWER PAN
Aqua Bath Transfer Shower Pan CP3636TD is molded from a single sheet of cast acrylic so as not to have any
joints or seams. Shall meet ANSI Z124.2. Shall meet ADA guidelines and other standards for accessibility.
Unit shall have a backside flame spread of less than 30 (Class B). Shall be designed to be ADA COMPLIANT
and NAHB LISTED. The enclosure shall have inside dimensions of 36" W x 36" D x 4" H and outside dimensions
of 38½" W x 37¼" D x 6" H. The unit shall be molded with a patented integral recessed "Trench Drain System"
so as to direct water to the front trench drain location. The approximate weight of the unit shall be 55lbs.
To be ADA compliant, top of threshold cannot exceed 1/2" above finished floor material.
The transfer shower pan shall be equipped with the following factory installed accessory: 1) Self-caulking brass
drain with stainless steel strainer (not installed). 2) Ribbed bottom for slip resistance (standard).
AVAILABLE OPTIONS
1) Available in model CP3636BF - This unit is the same as the above stated unit except it will have
a center drain location.
2) ASTM F462 non-slip bottom (see drawing CP3636TD-VB). (*) When the ASTM F462 bottom is specified,
a signed off approval is required for the bottom re-configuration.
Modifications: Received and / or approved by:
Please check with your local city and
state for code compliancy. Aqua Bath's
advertised ADA compliant units are
based on our interpretation of the
Americans with Disabilities Act 1991
Guidelines. Field alterations or improper
installation could take the units out of
compliance. Aqua Bath accepts no
responsibility for final code compliance.
For additional information, call the
Aqua Bath Customer Service
Department At 1-800-232-2284