HiVi H4 - Manual (Page 3)

1.When combined to form 2.0 speaker system, connect as below:
2.H4 2.0 system connecting with computer, MP3 / MP4
Insert the connection cable into the INPUT on the back panel of the speaker and the
OUTPUT of the computer sound card or the OUTPUT of the MP3 / MP4.
3.H4 2.0 system connecting with DVD player
Insert one end of the connection cable into the INPUT on the back of the speaker,
insert the other end into the OUTPUT of the DVD Player.
4.H4 5.1 system connecting with the subwoofer
Insert one end of the five speaker cables into the OUTPUT, FL, FR, SL, SR, C on the
back of the subwoofer, insert the other end into the INPUT of the H4. Fully insert the
plug to make sure the connection is firm to avoid influencing sound quality.
5. Plug in the H4 power cable to the AC outlet
6. Check all steps above to make sure all connections are all right.
Notice:
a.Please make sure the power is switched off when connecting the power cable.
b.Make sure connections are firm to avoid influencing sound quality.
c.The quality of cables will directly influence the sound quality. We suggest using
the provided signal cables, however you may also choose to purchase 2 party
audio cables.
V. Listening
1.Turn on the computer or other sound source, turn on the volume control to Minimum
(0)
2.Play the MP3, CD, and turn up the volume gradually.
3.Adjust the volume control to have proper volume. You can enhance or attenuate the
strength of the high, mid, or low frequency sound by adjusting the four function wave
band keys ( see below)
HF: High Frequency adjustment
Switch to “0”, the high frequency will be flat
Switch to “+1”, the high frequency will be increased 1dB
Switch to “-1”, the high frequency will be reduced 1dB
MF: Mid-range adjustment
Switch to “0”, the mid-range will be flat
Switch to “-2”, the midrange will be reduced 2dB
Switch to “-4”, the midrange will be reduced 4dB
When the speaker is placed on a bigger desk, we suggest switching to “-2” or “-4”
LF: Low frequency adjustment
Switch to “0”, the low frequency will be flat
Switch to “+2”, the low frequency will be increased 2dB
Switch to “-2”, the low frequency will be reduced 2dB
HP: High pass filter
Switch to “60Hz”, then the cut-off low frequency is 60Hz.
Switch to “66Hz”, then the cut-off low frequency is 66Hz.
Switch to “72Hz”, then the cut-off low frequency is 72Hz.
Notice：
A) As the H4 is a Hi-End multimedia system, we suggest using a high quality sound
card so that it can produce the best possible high-fidelity sound. Using a poor quality
sound card will degrade the sound quality.
B) Please do not have the volume turned up to the maximum while turning on the
power. The amplifier or drivers could be damaged.