Sunlight Supply Titan Controls® Hades® 1 - 15 Minute Lighting Delay Timer - Manual

Instructions for Use
1. Mount Hades 1 near the light or lighting timer to be
operated, but away from water, spray, mist, etc.
2. Plug the light power cord or relay trigger cord set
into your 24 hour timer.
3. Plug your 24 hour timer into the Hades 1.
3. Plug the Hades 1 into a 120 volt outlet. This begins
a 15 minute delay. Then your lights will turn on.
4. Your lighting timer will start a 15 minute delay
period if your lights should turn off due to a power
failure to avoid ‘Hot Starting’ your lamps.
Controller Specifications
Size: 4"H x 2" W x 2.5"D
Weight: 1 lb.
Voltage Input: 120 volts
Voltage Output: 120 Volts
Maximum Amperage: 15 Amps
Hertz: 60 Hz
Time Delay: 15 minutes
Operating Temperature: 35º to 125º F / 2º to 53º C
Storage Temperature: 32º to 135º F/ 0º to 57º C
Cord set: Wall Mount
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Hades 1
Lighting Delay Timer
Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
®
®
Controlling an Apollo 4 System
Controlling a Lighting System
Controlling a Single 120 Volt Ballast
24 Hour
Timer
Hades 1
120 Volt
Outlet
Ballast
120
Volt Relay
Tri
gge
r Cordset
Sun System R
Helios
Lighting
Controller
Sun System R
Ballast
Hades 1
Apollo 4
120 Volt
Outlet
Sun System R Ballast
Hades 1
120 Volt
Outlet
24 Hour
Timer
Hades 1
120 Volt
Outlet
Ballast
120
Volt Relay
Tri
gge
r Cordset
Sun System R
Helios
Lighting
Controller
Sun System R
Ballast
Hades 1
Apollo 4
120 Volt
Outlet
Sun System R Ballast
Hades 1
120 Volt
Outlet
24 Hour
Timer
Hades 1
120 Volt
Outlet
Ballast
120
Volt Relay
Tri
gge
r Cordset
Sun System R
Helios
Lighting
Controller
Sun System R
Ballast
Hades 1
Apollo 4
120 Volt
Outlet
Sun System R Ballast
Hades 1
120 Volt
Outlet