RADWAG PUE C indicator - Manual (Page 14)

EXI-01-04-06-14-GB - 14 -
3.3. Switching on
• Press the ON/OFF key
– keep pressing for about 1 sec.
• After switching on, wait for the test completion.
• The indication shall equal zero and the following pictograms shall be
seen:
- zero indication
- equilibrium
kg - weighing mode
• If the indication does not equal zero press the zeroing key
.
Ready to use.
4.
CLEANING
Cleaning can be performed only after unplugging from mains (230V AC). Use agents and
materials that do not cause gathering electrostatic charges on elements of the scale!
Do not use abrasive agents and solvents because
it can cause damage of the casing.
Cleaning should be performed when the appearance of explosive
gases is impossible
5.
SERVICE AND REPAIRING