Antennas Direct DB8 Antenna - Manual

1.
2.
3.
4. Next, attach the cross braces to the rear of the
as shown using supplied bolts.
4.
2. Attach combining bars to the binding posts
on the antenna (bow tie) elements. Tighten
using supplied wing nuts. This electrically
joins both halves of the antenna.
3. Left, both sets of elements joined with the
combiner bars. The transformer is in the center.
1. The DB8 comes with:
• 2 reflectors
• 2 sets of bow tie elements
• Combiner bars with 75 ohm transformer
• 4 sets of bolts with aluminum sleeves
• 2 cross braces
• 2 Mast clamps
DB8 Antenna Assembly