Antennas Direct ClearStream 2 Indoor/Outdoor DTV Assembly Instructions - Manual

Quick Start Assembly/Install Instructions
CLEARSTREAM 2 ™ WITH MOUNT
Before attaching the antenna to any surface, TEST RECEPTION in that area.
Connect the antenna to the TV or receiver and run a full channel scan.
If reception is not as desired move the antenna and rescan TV/receiver.
1
2
3
4
5
6
7
8
9
10
11
12
Indoor Wall / Outdoor Roof Mount
Tools Required: Adjustable Wrench, Power Drill, 5/16” Drill Bit,
Medium-sized Cross Point Screwdriver.
Thread coaxial cable
through reflector (1)
then hole in loop
element base (2) and
connect cable to
connector on back of
loop element (3).
Secure reflector, base
and loop together with
3 ½” bolt. Thread coaxial cable
through reflector (1)
then hole in loop
element base (2) and
connect cable to
connector on back of
loop element (3).
Secure reflector, base
and loop together with
3 ½” bolt.
Free-Standing Indoor Use
Tools Required: Adjustable Wrench
3
4
5
Place mast (4) into middle of
mast base (5) and secure with 2
hex bolts.
4
1. Reflector
2. Loop Element Base
3. Loop Element
4. J Mount Mast
5. Mast Base
6. Plastic Base Cover
7. Circular Base
8. Hex Bolts
9. 3 ½” Bolt
10. Expansion
Mounting Bolts
11. Weather Boot
12. J-mount Mast
End Cap
Call Our HELP LINE at 877-825-5572
One of our specialists can talk you through
any problems you may have.
Install antenna on mast
(4) by positioning clamp
on to mast. Install wing
nuts but do not tighten
them completely.
Mark mast base position
on your surface. Adjust
mast so it is vertical and
tighten nuts. Drill a 5/16”
hole, 1½ inches deep
for each mounting bolt.
Insert expansion bolts
and tap into position.
Place base over
mounting bolts, then
tighten nuts to secure
bolts and base to your
surface.
Point antenna in direction
of your TV stations’
transmission towers, (to
locate your towers, go to
antennapoint.com or
contact your local tv
stations). Fully tighten
wing nuts. Connect opposite end of coaxial cable to your TV or
receiver. Perform channel scan and check reception. NOTE: For
outside installation, we have included a weather boot (12) which
can be cut to cable connector size.
1 1
2
4
Place mast (4) into middle of
mast base (5) then adjust mast
to vertical position and secure
with 2 hex bolts.
2
4
3
3
4
Slip plastic base cover
(6) over mast, nesting
metal base into plastic
base cover. Place
mast/plastic base cover
assembly on circular
base (7) and snap
together.
6
7
Install antenna on mast (4) by
slipping clamp on back of
reflector (1) over mast pipe and
tighten wing nuts.
Point antenna in direction of
your TV stations’ transmission
towers, (to locate your towers,
go to antennapoint.com or
contact your local tv stations).
Connect the opposite end of
coaxial cable to your TV or
receiver. Perform channel scan
and check reception.
Before beginning assembly, make sure all pieces needed are present.
1
5
2
3
1
2