Antennas Direct ClearStream 2 VHF - Manual

Quick Start Assembly/Installation Instructions
CLEARSTREAM 2 ™ COMPLETE
Before attaching the antenna to any surface, TEST RECEPTION in that area.
Connect the antenna to the TV or receiver and run a full channel scan.
If reception is not as desired, move the antenna and rescan TV/receiver.
4
Before beginning assembly, make sure all pieces needed are present.
8.5”
14”
Knowledgeable Tech Support
Technical Assistance is available Monday - Friday, 9am - 9pm Central Time
and Saturday - Sunday, 10am - 6pm.
©Antennas Direct 2011 05/11 C2-J30-V
Outdoor Roof Mount
Tools Required: Adjustable Wrench, Power Drill, 3/16” Drill Bit,
8 and 10mm Ratcheting Drivers’ Medium-sized Cross Point Screwdriver.
Thread coaxial cable with the
weather boot (9) through
reflector then through hole in
loop element base (1) and
connect cable to connector on
back of loop element (3).
Secure reflector, base and
screw together with 3 ½” bolt (6).
Install antenna on mast (4) by
positioning clamp onto mast.
Install wing nuts but do not tighten
them completely.
When reception is as desired, tighten
wing nuts to secure antenna to the mast.
Connect opposite end of
coaxial cable to your TV or
receiver. Point antenna in
direction of your TV stations’
transmission towers, and check
reception by scanning for
channels. If reception is not as
desired move antenna and
rescan.
Mark mast base position on
your surface. Drill a 3/16” hole,
1½ inches deep for each
mounting bolt (7). Place roof
sealing pads (11) then tighten
bolts to secure base to your
surface.
Place the J-mount end cap on
the end of the mount.
1
2
3
4
1
2
3
4
5
6
7
8
9
9
4
8
5
11
7
1
3
6
10
11
Attach J-mount
to mount base
with Hex bolts
Raise dipole
And click into place.
Raise dipole
And click into place.
Leave cables
twist-tied to reflector
1) Reflector with
Loop Element Base
and Collapsable
Dipole
2) 30 ft. Coax Cable
3) Loop Element
4) J-mount Mast
5) Hex Bolts
6) 3 ½” Bolt
7) ¼” x 50mm
Mounting Bolts
8) Mount Base
9) Weather Boot
10) J-Mount Mast
End Cap
11) Roof Sealing Pads