Silent Call CR30 - Manual

Revision 1
5095 Williams Lake Road, Waterford Michigan 48329
(800) 572-5227 (Voice / TTY)
"Crystal Reflections" CR30
An alerting device with style!
Congratulations on purchasing the CR30 wireless multi-function
alerting device from Silent Call Communications. The CR30
represents a new era in wireless alerting devices… functional yet
attractive and stylish at the same time. Place the CR30 on a table
and no one has to know that it is an alerting device.
The CR30 is compatible with all Silent Call transmitters. The transmitter(s) may be placed
up to 100 feet the CR30. When the CR30 receives a signal from a transmitter, it flashes
its decorative crystal in a unique flash pattern for each received signal.
Setup
1. Plug the connector on the supplied AC adapter into the Power receptacle on the CR30
rear panel.
2. If desired, plug a telephone cable into the Input receptacle on the rear of the CR30
and into any telephone outlet. If there is no telephone outlet near the CR30, you can
also use a Silent Call telephone transmitter to activate the telephone indication.
3. Plug the power supply into an AC outlet. The CR30 will flash once, indicating it is ready
for operation as long as you have not changed the code switch setting in your
transmitters from the factory setting of OFF, OFF, OFF, ON, ON. If you have
changed the code switches, follow the steps in the programming section (below).
Operation
1. The CR30 crystal will flash a distinct pattern for each type of transmitter it hears.
The indication will continue for about 15 seconds after the transmitter stops
transmitting.
SOUND = three short flashes
PHONE = one long flash
DOOR = two short flashes
WEATHER = one short and one long flash
FIRE = continuous short flashes
CO = three short flashes and one long flash