American Standard 255.102 User Manual
Installation instructions, Porcelain enameled steel bathtubs
STRINGER
CARE AND CLEANING
S
A
VE FOR FUTURE USE
791524-100 Rev. A
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2012
0255.102 New Salem
®
Bathtub, RHO
0255.202 New Salem
®
Bathtub, LHO
Porcelain Enameled Steel Bathtubs
0263.102 New Solar
®
AFR Bathtub, RHO
0263.202 New Solar
®
AFR Bathtub, LHO
0138.014 Mackenzie
™
4-1/2' Bathtub, RHO
0139.011 Mackenzie
™
4-1/2' Bathtub, LHO
0131.012 Huron
®
4' Bathtub, RHO
0133.017 Huron
®
4' Bathtub, LHO
INSTALLATION INSTRUCTIONS
CAUTION: THIS NEW FIXTURE HAS A DURABLE FINISH; HOWEVER, EXTRA CARE SHOULD BE EXERCISED
DURING INSTALLATION WHEN ROUGH HANDLING AND THE DANGER OF DROPPED TOOLS
MAY CAUSE DAMAGE.
!
1
2
3
Check the tub thoroughly for
shipping damage, report any
apparent damage to the location
that furnished the tub and
request their advice on
continuing with the installation.
Protect this bathtub during
installation and construction by
using this corrugated container as
indicated. Cut along the dotted lines
and place the corrugated protector
over the top and front of the tub.
The center cut-out drops into the
center of the tub.
After measuring the dimensions
of the product, frame the
construction area.
4
5
6
Locate the tub in position and mark
a joist so that a 2x4 stringer can be
nailed in place. The stringer will be
located under the flange against
the wall. Nail in place the 2x4
support. Re-position the tub and
check for level, both front to back
and left to right.
Clean with warm water, a soft cloth
and mild detergent. Never use
abrasive scouring powders,
cleansers or pads.
It may be necessary to shim the tub
to achieve a good level condition.
Only small shims should be used in
conjunction with the bathtub’s own
support pad.
Note:There will be a small gap
between the apron panel and
the floor to allow for tile,
carpeting, etc. Caulking could
be used to seal this gap.
Overflow and drain assembly,
faucet and the shower head
should be installed to the
manufacturers specifications.
Over-tightening the drain can
damage the tub.