American Standard MONOBLOCK BIDET 2064.011 - Manual

M968851 Rev.1.3
Certified to comply with ANSI A112.18.1
Installation
Instructions
MONOBLOCK BIDET with
Speed Connect™ Drain
Adjustable Wrench Screwdriver Channel Locks
Recommended tools
Tubing Cutter
1
INSTALL FAUCET
Turn off hot and cold water
supplies before beginning.
CAUTION
2064.011
1
SERIN ™
1
2
5
6
4
4
GROOVE
(FAUCET
BASE)
MOUNTING
SURFACE
COLLAR ON
MOUNTING NUT
3
7
5
8
Seat SEAL (1) into under side of ESCUTCHEON RING (2).
Feed FAUCET SUPPLIES (3), MOUNTING STUD (4) and DRAIN
CABLE ASSEMBLY (8) through ESCUTCHEON RING (2) and the
mounting hole of lavatory or mounting surface. Figure A.
Seat ESCUTCHEON RING (2) with collar facing up into groove in
faucet base.
From below, push GASKET (7) and RETAINING WASHER (5) onto
MOUNTING STUD (4). Secure Faucet with MOUNTING NUT (6),
pulling faucet to front of sink, so SUPPLIES (3) rests against
mounting hole. Before final tightening, make sure collar on
MOUNTING NUT (6) is seated into RETAINING WASHER (5).
Figure B.
Adjust Faucet so that it is centered. Tighten MOUNTING NUT (6)
to complete faucet mounting.
Figure A
Figure B
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
Congratulations on purchasing your American Standard
faucet with Speed Connect drain, a feature found only on
American Standard faucets.
*Your new American Standard faucet is designed to work only with the Speed Connect drain.
Speed Connect Drain*
• Fewer parts, installs in less time
• Never needs adjustment
• Guaranteed to seal properly the first time, every time.