Network printing from a windows operating system – Konica Minolta bizhub 362 User Manual
Page 62
Setting up network printing
3
362/282/222
3-4
Network connection methods that can be selected in each Windows op-
erating system
This chapter describes the settings that must be specified for network print-
ing.
Setting procedures differ depending on the method of networking printing
used (Windows, LPR, or IPP printing). Select the best method of network
printing for your Windows environment.
Network printing from a Windows operating system
For details, refer to “Windows printing” on page 3-9.
2
Note
Before setting up network printing, install the printer driver. For details,
refer to “Installing the printer driver” on page 2-1.
To perform network printing, change the printer port for the installed
printer driver to one for a network connection, and then change the set-
tings on this machine as necessary. For an IPP connection, it is neces-
sary to install the printer driver first.
Only the PCL printer driver can be used with Windows printing. If network
printing with the PostScript printer driver, use LPR printing or Port 9100
printing.
Network printing in a NetWare environment
Protocol
used
Windows
2000
Windows
XP/Vista
Windows
NT 4.0
Windows
Server 2003/
Server 2008
Windows
printing
TCP/IP,
NetBEUI
+
+
+
+
LPR printing
TCP/IP
o
o
o
o
IPP printing
TCP/IP
o
o
o
Port 9100
printing
TCP/IP
o
o
o
NetWare version
Protocol used
Emulation
Service mode
NetWare 4.x
IPX
NDS/Bindery
Pserver/Nprinter
NetWare 5.x/6
IPX
NDS
Pserver
TCP/IP
NDPS(lpr)