Konica Minolta KIP Color 80 - Manual (Page 7)

1
1 Before Use
1. 1 Installation Requirements
The following conditions have to be satisfied when installing the Auto Stacker (K-113).
1. Satisfy the following input power condition.
Voltage 100-240VAC
Current 3A or higher
Frequency 50 / 60Hz.
The Auto Stacker (K-113) can be supplied with any voltage within 100V to 240V. If the voltage is
within this range, please connect to the outlet simply. (No setting has to be changed.)
2. Make sure to connect the power plug to the outlet that is provided with the Ground Terminal.
3. To completely disconnect the machine from the power source, draw the power plug from the
outlet.
The outlet must be easily accessible near the equipment.
4. The temperature must be within the range from 10 to 32.5 degrees centigrade, and the humidity
must be 20 to 85% RH.
5. Prevent the machine away from water, fire, dust or direct sunlight.
If it is impossible to avoid the direct sunlight, please pull the curtain to intercept the sunlight.
6. The floor must be enough strong to withstand machine’s weight (About 47kg).
7. Keep enough space around the machine as follows.
(The following values are the least requirements. Please keep a wider space if possible.)
More than 73cm
60cm
Machine
Printer
60cm
More than More than