Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-14674 - Manual (Page 16)

Using the lp utilities Using the lp Utilities for Solaris
The lp command syntax and options
This section gives the syntax for the lp command, and lists the
required and optional information you use to submit a print job.
Syntax lp –d <queue name> <options> <filenames>
Required –d <queue name>
Information
Identify the queue where you want to send the jobs.
<filenames>
Specify the names of the files to print. You must include any
filename extension when you type the filename. Using the
wildcard (*) character is not recommended.
Using lp with Solaris 2.6
Sun Microsystems has discontinued support for the System V
Print Protocol in Solaris 2.6. In order to use the lp utilities to print
to the DocuSP controller running Solaris 2.6, refer to the chapter,
Installation, for procedures to set up lp submission from a client
workstation.
NOTE: When using lp on the DocuSP controller for local print
submission, the –c switch must be included. The syntax required
is:
lp -d <queue name> -c -o <options> <job name>
2-2