AMX Modero NXD/NXT-1200VG - Manual (Page 188)

Displaying Stream Content
174 VG-Series Modero Touch Panels
3. From within the Video section of this page, check off the appropriate Video In and Video Port radio boxes
which correspond to both the type of video signal being used and its associated format.
 For the purpose of these procedures, we’ve chosen to feed an NTSC signal into the rear Composite
video connector. As a result, a user should "check-off"/select both the Composite and NTSC radio
boxes.
4. If you are feeding a microphone audio signal into the rear MAX-CSE microphone connector, you could
use the Microphone Gain field to enter an audio level (0 - 99) associated with the gain used by the rear
microphone input.
5. Click the Apply button to save the encoding profiles to the MAX-CSE.
Step 4: Setup a streaming page within TPDesign4
1. Launch TPDesign4 (default location is Start > Programs > AMX Control Disc > TPDesign4 >
TPDesign4). Refer to the TPDesign4 Instruction Manual for more detailed instructions of these
procedures.
2. From the menu bar, select File > New (or click the New Project toolbar button).
3. From within the Step 1 dialog, enter a generic Job name and use the Panel Type drop-down arrow to
choose a VG-Series panel (1200VG, 1500VG, or 1700GVG).
 For the purpose of these procedures, we’ve chosen to use a Job Name of Test and have selected an
NXD-1700VG touch panel (FIG. 137).
FIG. 136 A/V Setup page
Video Port and Video Format
Mic Gain value for incoming
audio signal
At any time, the user can choose to mute the incoming microphone signal by either
toggling the state of the Microphone icon located at the top of the page or entering a
value of zero into the Mic Gain field.