06 watching tv, Turning on/off the power, Watching tv 06 – Pioneer PDP-506XDE User Manual

Page 23: Watching tv, Timer standby on standby/on pull open

Advertising
background image

23

En

Watching TV

06

En

gl

is

h

Watching TV

Unless you set up TV channels that you can watch under the
current conditions, you cannot tune in those channels. For the
procedure, see “Setting up TV channels automatically” on page
30.

Turning on/off the power

NOTE

• When the Media Receiver is plugged into a power outlet, it is

placed into the standby mode; the STANDBY indicator on its
front panel should flash red. The Media Receiver stays in the
standby mode unless it is unplugged from the power outlet.

To turn on the system, press

POWER on the Plasma Display.

• The POWER ON indicators on the Plasma Display and Media

Receiver light up in blue.

To turn off the system, press

a on the remote control unit or

STANDBY/ON on the Media Receiver.
• The Plasma Display and Media Receiver are placed into the

standby mode; their respective STANDBY indicators light up
in red.

• You can then turn on the system again by pressing

a or

0 to

9 on the remote control unit or STANDBY/ON on the Media
Receiver. If you press

0 on the remote control unit, images

come from the INPUT 1 source. If you press

1 to 9, TV images

display.

You can also press

POWER on the Plasma Display to turn off

the system. However, you cannot then turn on the system
again by pressing the buttons on the remote control unit and
Media Receiver.

NOTE

• Before operating with the remote control unit, make sure to

select the TV mode using its

SELECT button. See “Controlling

other equipment using the supplied remote control unit” on
page 69.

• It is recommended not to unplug the Media Receiver from a

power outlet when it is not in use. When in the standby
mode, the Media Receiver automatically receives Electronic
Programme Guide and DTV Auto Update signals.

• When the system is placed into the standby mode, the main

power flow is cut and the system is no longer fully
operational. A minute flow of power feeds the system to
maintain operation readiness.

• If you are not going to use the Plasma Display System for a

long period of time, be sure to remove the power cord from
the power outlet.

Plasma Display/Media Receiver status indicators

The table below shows the operational status of the Plasma
Display System. You can check the current status of the system
with the indicators on the Plasma Display and Media Receiver.

Plasma Display

Media Receiver

For other than the above, see “Troubleshooting” on page 76.

STANDBY indicator

POWER ON indicator

POWER button

TIMER

STANDBY

ON

STANDBY/ON

PULL
OPEN

POWER ON indicator

STANDBY indicator

STANDBY/ON button

TIMER indicator

1

1

2

3

4

5

6

7

8

9

PC

0

2

3

4

INPUT

INFO

INPUT 5

TV/DTV

SELECT

TV

STB

DVD/

DVR VCR

SOURCE

P

Indicator Status

System Status

Plasma Display

Media Receiver

POWER ON

STANDBY

POWER ON

STANDBY

The power cords of both the Plasma Display and the Media Receiver have been
disconnected. Or, the power cord of the Plasma Display has been connected but
the

POWER button of the Plasma Display is off.

Power to the system is on.

The system is in the standby mode.

Flashing

The power cord of the Media Receiver has been disconnected.

Flashing

Power to the Plasma Display is off. Or the power cord of the Plasma Display has
been disconnected.

PDP506XDE.book Page 23 Friday, June 17, 2005 3:08 PM

Advertising
This manual is related to the following products: