Pioneer PDP-506XDE - Manual (Page 38)

38
En
Basic Adjustment Settings 08
Power Control
Power Control provides convenient functions for power saving.
Energy Save
You may use one of the three Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select “Power Control” ( / then ENTER).
3
Select “Energy Save” ( / then ENTER).
4
Select “Save 1”,”Save 2”, or “Picture Off” ( / then
ENTER).
5
Press HOME MENU to exit the menu.
NOTE
• You can also select this function using the Home menu
when the input source is a PC.
No Signal off (AV mode only)
The system will be automatically placed into the standby mode
if no signal is received for 15 minutes.
1
Press HOME MENU.
2
Select “Power Control” ( / then ENTER).
3
Select “No Signal off” ( / then ENTER).
4
Select ”Enable” ( / then ENTER).
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Media Receiver after a TV
programme finishes.
No Operation off (AV mode only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1
Press HOME MENU.
2
Select “Power Control” ( / then ENTER).
3
Select “No Operation off” ( / then ENTER).
4
Select “Enable” ( / then ENTER).
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
Power Management (PC mode only)
The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1
Press HOME MENU.
2
Select “Power Control” ( / then ENTER).
3
Select “Power Management” ( / then ENTER).
4
Select “Mode 1” or “Mode 2” ( / then ENTER).
5
Press HOME MENU to exit the menu.
Item Description
Standard Does not decrease the picture brightness.
Save1 Slightly lowers power consumption while
slightly suppressing the brightness drop level.
Save2 Decreases the picture brightness and lowers
power consumption.
Picture Off Deactivates the screen to save power. To restore
the screen display, press any button other than
i +/i – and e.
This setting is not memorised by the system.
Item Description
Disable
(factory default) Does not place the system into the standby
mode.
Enable Places the system into the standby mode if no
signal is received for 15 minutes.
Item Description
Disable
(factory default) Does not place the system into the standby
mode.
Enable Places the system into the standby mode if no
operation is performed for three hours.
Item Description
Off
(factory default) No power management
Mode1 • Places the system into the standby mode
when no signal is received from the personal
computer for eight minutes.
• Even when you start using the computer and
a signal is received again, the system stays
off.
• The system is switched on again by pressing
STANDBY/ON on the Media Receiver or TV
a on the remote control unit.
Mode2 • Plac es the system into the standby mode
when no signal is received from the personal
computer for eight seconds.
• When you start using the computer and a
signal is input again, the system is switched
on.
• The system is switched on again by pressing
STANDBY/ON on the Media Receiver or TV
a on the remote control
unit.
PDP506XDE.book Page 38 Friday, June 17, 2005 3:08 PM