Pioneer PDP-503HDE - Manual (Page 38)

36
Basic adjustment settings
MENU
Power Control
No signal off [Enable]
Disable
Enable
MENU
Power Control
No operation off [Enable]
Disable
Enable
Power control
Power Control setting allows you to reduce the display brightness to save energy.
No signal off
When set to “Enable”, the power will automatically shut
down if no signal inputs for 15 minutes.
1
Press MENU.
2
Press / to select “Power Control”, and then press
ENTER.
3
Press / to select “No signal off”, and then press
ENTER.
4
Press / to select “Enable”, and then press
ENTER.
5
Press MENU to exit the menu.
• Five minutes before the power shuts down, hazard
warning displays every minute.
A
• “Disable” is factory preset value.
• Return to the previous menu by pressing n.
• When a TV programme finishes, and the Media Receiver
receives signal input, this function may not operate.
No operation off
When set to “Enable”, the power will automatically shut
down if the signal stays inactive for 3 hours.
1
Press MENU.
2
Press / to select “Power Control”, and then press
ENTER.
3
Press / to select “No operation off”, and then
press ENTER.
4
Press / to select “Enable”, and then press
ENTER.
5
Press MENU to exit the menu.
• Five minutes before the power shuts down, hazard
warning displays every minute.
A
• “Disable” is factory preset value.
• Return to the previous menu by pressing n.
ENTER
MENU
/
MENU
Power Control
Energy Save [Save]
Standard
Save
Power control for AV source
Energy save
When set to “Save”, the power consumption is saved
by degrading picture brightness.
1
Press MENU.
2 Press / to select “Power Control”, and then press
ENTER.
3
Press / to select “Energy Save”, and then press
ENTER.
4
Press / to select “Save”, and then press ENTER.
5 Press MENU to exit the menu.
A
• “Standard” is factory preset value.
• Return to the previous menu by pressing n.
PDP-503HDE/(E)-c 8/31/02, 5:48 PM 36