Pioneer PDP-503HDE - Manual (Page 39)

37
MENU
Power Control
Power Management [Off]
Off
Mode2
Mode1
MENU
Power Control
Energy Save [Save]
Standard
Save
Basic adjustment settings
Power management
When set, the power will automatically shut down.
1
Press MENU.
2
Press / to select “Power Control”, and then press
ENTER.
3 Press / to select “Power Management”, and then
press ENTER.
4
Press / to select “Mode1” or “Mode2”, and then
press ENTER.
5
Press MENU to exit the menu.
A
• Return to the previous menu by pressing n.
Description
• No power management
• Factory preset value.
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the computer and
the signal inputs again, the System stays
off.
• The System turns on again by pressing
STANDBY/ON on the Plasma Display or 0
– 9 on the remote control unit. The System
is out of PC mode. (See page 13.)
• If no signal inputs for 8 seconds, the power
shuts down.
• When you start using the computer and the
signal inputs again, the System turns on.
Selected item
Off
Mode1
Mode2
ENTER
MENU
/
Power control for PC source
Power control allows you to reduce display brightness
and save energy.
Energy save
1 Press MENU.
2
Press / to select “Power Control”, and then press
ENTER.
3
Press / to select “Energy Save”, and then press
ENTER.
4 Press / to select “Save”, and then press ENTER.
5
Press MENU to exit the menu.
A
• “Standard” is factory preset value.
• Return to the previous menu by pressing n.
PDP-503HDE/(E)-c 8/31/02, 5:48 PM 37