Pioneer DJM-1000 - Manual (Page 16)

OTHER (TROUBLESHOOTING)
16
<DRB1372>
En
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think there is something wrong with this component,
check the points below. Sometimes the trouble may originate from another component. Thus, also check the other electrical appli-
ances also in use.
If the trouble cannot be rectified even after checking the following items, contact your dealer or nearest PIONEER service center.
Static electricity or other external interference may cause the unit to malfunction. To restore normal operation, turn the power off and
then on again.
Symptom
Power does not turn on.
Little or no sound.
Sound is distorted.
Cannot cross fade.
Cannot fader start the CD player.
External effector’s sound is
distorted.
External effector doesn’t operate.
Link function doesn’t work.
Possible Cause
÷ The power cord has not been connected.
÷ Input selector switch is in the wrong
position.
÷ Connection cable hasn’t been connected
properly or has been disconnected.
÷ Connector or plug is dirty.
÷ MASTER ATT. dial on rear panel is set
too low ([–12 dB], etc.).
÷ Master output level is too high.
÷ Input level is too high.
÷ The setting of the CROSS FADER ASSIGN
switch ([A], [THRU], [B]) is incorrect.
÷ The fader start switch is set to OFF.
÷ The rear panel’s player CONTROL
connector hasn’t been connected.
÷ The input level from the external effector
is too high.
÷ The SEND/RETURN button is turned OFF.
÷ The effector is not connected to the
RETURN connector or EFX connector
located in the rear panel.
÷ The SEND channel selector switch setting
is mistaken.
÷ A device supporting digital link is not
connected to the digital link connectors
(EFX 1, EFX 2, SOUND 1, SOUND 2,
VISUAL) in the rear panel.
Countermeasure
÷ Connect the cord to a power outlet.
÷ Choose the device currently playing with the
input selector switch.
÷ Connect properly.
÷ Clean and reconnect.
÷ Adjust the setting of the MASTER ATT. dial
in the rear panel.
÷ Adjust the MASTER ATT. dial in the rear
panel.
÷ Adjust the TRIM dial so that the input level
approaches 0 dB on the CHANNEL LEVEL
indicators.
÷ Set the CROSS FADER ASSIGN switch of the
channel desired to cross fade properly.
÷ Set the fader start switch to ON.
÷ Use the control cable to connect the unit and
CD player.
÷ Lower the external effector’s output level, or
adjust the return level using the RETURN
dial (LEVEL).
÷ Turn the SEND/RETURN button ON.
÷ Connect the effector to either the SEND/
RETURN connector or the EFX 1 or EFX 2
connectors in the rear panel.
÷ Select the source to which you want to
apply effects with the SEND channel selector
switch.
÷ Use a digital link cable to connect the DJM-
1000 to a supported device.
Check the following items if the link connection is not established properly:
CAUTION Indicators
Each link indicator flashes twice.
Each link indicator flashes three
times.
Each link indicator flashes four
times.
Meaning
Unsupported components are connected at
the link input/output connectors.
The link connectors of a single DJM-1000
are connected together, or the link
connectors from two DJM-1000s are
connected together.
Communication error occurred at the link
input/output connectors.
Countermeasure
Check the connections at the link input/output
connectors.
Check connections.
Check connections and connector cables.