Pioneer AVH-X8600BT - Manual (Page 133)

Symptom Cause Action
The smartphone was not
charged. Charging stopped because the tem-
perature of the smartphone rose
due to prolonged use of the smart-
phone during charging. Disconnect the smartphone from the cable,
and wait until the smartphone cools down.
More battery power was consumed
than was gained from charging. This problem may be resolved by stopping
any unnecessary services on the smartphone.
Error messages
When problems occur with this product, an error message appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
record the error message and contact your dealer or your nearest Pioneer service centre.
Common
Message Cause Action
AMP Error This product fails to operate or the
speaker connection is incorrect; the
protective circuit is activated. Check the speaker connection. If the mes-
sage fails to disappear even after the engine
is switched off/on, contact your dealer or an
authorised Pioneer Service Station for assis-
tance.
Product overheat. System will
be shut down automatically
in 1 minute. Restart the pro-
duct by ACC-Off/On may fix
this problem. If this message
keep showing up, it is possi-
ble that some problem oc-
cured in the product. The temperature is too high for this
product to operate. Follow the instructions displayed on the
screen. If this does not solve the problem,
contact your dealer or an authorised Pioneer
Station for assistance.
Aha Radio
Message Cause Action
Communication error oc-
curred. iPod failure. Disconnect the cable from the iPod. Once the
iPod
’s main menu is displayed, reconnect the
iPod and reset it.
Error-02-6X iPod failure. Disconnect the cable from the iPod. Once the
iPod
’s main menu is displayed, reconnect the
iPod and reset it.
Disc
Message Cause Action (Reference)
Error-02-XX/FF-FF The disc is dirty. Clean the disc.
The disc is scratched. Replace the disc.
The disc is loaded upside down. Check that the disc is loaded correctly.
There is an electrical or mechanical
error. Press the RESET button. (Page 11)
Engb
133
Appendix
Appendix
Appendix