Pioneer DJM-400 - Manual (Page 5)

5
<DRB1404>
En
English
CONNECTIONS
CONNECTING INPUTS
Pioneer DJ CD players
Connect a DJ CD player’s audio output connectors to one of the
channel 1 to 2 CD input connectors, and connect the player’s control
cable to the corresponding channel’s CONTROL connector.
Set the connected channel’s input selector switch to [CD].
Analog turntable
To connect an analog turntable, connect the turntable’s audio output
cable to one of the channel 1 to 2 PHONO/LINE input connectors. Set
the corresponding channel’s PHONO/LINE switch to [PHONO], and
set the channel’s input selector switch to [PHONO/LINE]. The DJM-
400’s PHONO inputs support MM cartridges. Connect the turntable’s
ground wire to the DJM-400’s SIGNAL GND terminal.
Connecting other devices with line level output
To use a cassette deck or other CD player, connect the component’s
audio output connectors to one of the channel 1 to 2 PHONO/LINE
input connectors. Then set the corresponding channel’s PHONO/
LINE switch to [LINE], and the input selector switch to [PHONO/LINE].
Microphone
The MIC1 and MIC2 jacks can be used to connect microphones with
Ø6.3 mm phone plugs. Set MIC/AUX switch to [MIC] position.
Auxiliary input connectors
The MIC1 and MIC2 jacks can also be used together as a pair of stereo
line input connectors to connect a component equipped with line
level output connectors. Connect the component’s L channel to MIC1
(AUX(L)) jack and the R channel to the MIC2 (AUX(R)) jack. Then set
the MIC/AUX switch to [AUX] (this connection requires the use of
Ø6.3 mm phone plugs).
CONNECTING OUTPUTS
Master output
This unit is furnished with MASTER OUT 1 and MASTER OUT 2
output systems, both of which support the use of RCA plugs.
If the unit’s STEREO/MONO switch is set to [MONO], the master
output will be a monaural combination of L+R channels.
Always turn off the power switch and disconnect the power plug from its outlet when making or changing connections.
POWER
OFF ON
AC IN
MASTER
OUT
MONO STEREO
2 1
L
R
L
R
LINE PHONO
LINE
PHONO
MIC2 MIC1
AUX(R) AUX(L)
AUX MIC
CD
CONTROL
L
R
LINE PHONO
LINE
PHONO CD
CONTROL
SIGNAL
GND
L R L R L R L R L R
R
L
MIC/AUX switch
Input selector switches
Microphone 2
Microphone 1
PHONO/LINE switch
Note:
Set switch to [LINE]
except when using
an analog turntable
Electronic instrument,
CD player, etc. (phone
plug connection)
Cassette deck, etc. Analog turntable Analog turntable DJ CD player DJ CD player
Headphones
The front panel PHONES jack can be used to connect headphones
with a Ø6.3 mm stereo phone plug.
POWER
OFF ON
AC IN
MASTER
OUT
MONO STEREO
2 1
L
R
L R L R
STEREO/MONO switch Front panel
Power amplifier
Cassette deck, etc.
(analog input recording
component)
Power amplfier Headphones
CONNECTING THE POWER CORD
Connect the power cord last.
÷ After completing all other connections, connect the accessory
power cord to the AC inlet on the back of the player, then connect
the plug to a standard wall outlet or to the auxiliary power outlet
of your amplifier.
÷ Use only the supplied power cord.