Pioneer TAD-R1 - Manual (Page 10)

10
TAD Reference One Owner’s Manual
Choosing Where To Place The Loudspeakers
Loudspeaker placement within the listening room will have a great impact upon the total performance of TAD
Reference One loudspeakers in terms of bass performance, tonal accuracy, and imaging. All rooms are different and
so this section is intended as a guide only. Experimentation in your room will yield optimum results.
Begin by placing the rear of the loudspeakers approximately one to two feet in from the front walls and the sides
one to two feet in from the side walls of your listening room, as shown in Figure 7. Your listening position should
be roughly equal to the distance between the two loudspeakers. Also, turn the loudspeakers inward so each axis
points toward the listening position.
Next, connect the audio system as described in CONNECTING THE LOUDSPEAKERS on the next page. Then,
optimize the loudspeaker placement as described in OPTIMIZING THE SYSTEM on page 16.
WARNING!
Keeping the spikes inserted can cause damage to the bottom of the unit in the event that you move
the loudspeaker. Be sure to remove the spikes before moving the loudspeaker to another location.
In order to protect the bottom of the unit from damage when moving the loudspeaker, you should
place a thick cloth or mat beneath the system before moving it to a new location.
TAD-R1_En.book 10 ページ ２００６年１２月４日 月曜日 午後２時４２分