Pioneer PDP 434HDE - Manual (Page 22)

07 Watching TV
22
En
Plasma Display
POWER ON indicator
POWER button
STANDBY indicator
Media Receiver
POWER ON indicator
POWER button
STANDBY/ON button
Unless you set up TV channels that you can watch
under the current conditions, you cannot tune in those
channels. For the procedure, see “Setting up TV chan-
nels automatically” on pages 29 to 30.
STANDBY indicator
(right view)
Turning on the power
1 Press POWER on the Plasma Display.
• The STANDBY indicator on the Plasma Display
flashes red.
2 Press POWER on the Media Receiver.
• The system is turned on or placed into the
standby mode.
3 Confirm that the STANDBY indicators light up red,
and then press any button from 0 to 9 on the
remote control unit or STANDBY/ON on the
Plasma Display to turn the system on.
• In the standby mode, when you press 0, the
power turns on and the on-screen image comes
from the INPUT 1 source. Or, when you press
any button from 1 to 9, a TV image displays.
• The POWER ON indicators on the Plasma
Display and Media Receiver light up in green.
• In this manual, “system” mean the Plasma Display
Panel and Media Receiver.
• You can also reverse steps 1 and 2.
Turning off the power
1 Press a on the remote control unit or STANDBY/
ON on the Plasma Display.
• The system enters standby mode and the image
on the screen disappears.
• Both STANDBY indicators light up in red.
• It is recommended to place the system into the
standby mode after using it. This allows the
system to automatically receive Electronic
Program Guide information signals in the
standby mode.
2 Press POWER on the Media Receiver.
• The STANDBY indicator on the Media Receiver
turns off and the one on the Plasma Display
flashes red.
3 Press POWER on the Plasma Display.
• The STANDBY indicator on the Plasma Display
turns off.
• You can also reverse steps 2 and 3.
• If you are not going to use this system for a long
period of time, be sure to remove the power cord
from the power outlet.
• When the system is placed into the standby mode,
the main power flow is cut and the system is no
longer fully operational. A minute flow of power feeds
the system to maintain operation readiness.