English, Din front/rear mount, Installation – Pioneer DEH-X9500BT User Manual

Page 2

Advertising
background image

Important

! Check all connections and systems before

final installation.

! Do not use unauthorized parts as this may

cause malfunctions.

! Consult your dealer if installation requires

drilling of holes or other modifications to the
vehicle.

! Do not install this unit where:

— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result

of a sudden stop.

! The semiconductor laser will be damaged if

it overheats. Install this unit away from hot
places such as near the heater outlet.

! Optimum performance is obtained when the

unit is installed at an angle of less than 60°.

60°

! When installing, to ensure proper heat dis-

persal when using this unit, make sure you
leave ample space behind the rear panel and
wrap any loose cables so they are not block-
ing the vents.

5cm

cm

Leave ample
space

5 cm

5 cm

DIN front/rear mount

This unit can be properly installed using either
front-mount or rear-mount installation.

Use commercially available parts when instal-
ling.

DIN Front-mount

1

Insert the mounting sleeve into the dash-

board.
For installation in shallow spaces, use the sup-
plied mounting sleeve. If there is enough space,
use the mounting sleeve that came with the ve-
hicle.

2

Secure the mounting sleeve by using a

screwdriver to bend the metal tabs (90°) into
place.

1

2

1 Dashboard
2 Mounting sleeve

# Make sure that the unit is installed securely in
place. An unstable installation may cause skipping
or other malfunctions.

DIN Rear-mount

1

Determine the appropriate position

where the holes on the bracket and the side
of the unit match.

2

Tighten two screws on each side.

1

2

3

1 Tapping screw (5 mm × 8 mm)
2 Mounting bracket
3 Dashboard or console

Removing the unit

1

Remove the trim ring.

1 Trim ring
2 Notched tab
! Releasing the front panel allows easier ac-

cess to the trim ring.

! When reattaching the trim ring, point the

side with the notched tab down.

2

Insert the supplied extraction keys into

both sides of the unit until they click into
place.

3

Pull the unit out of the dashboard.

Removing and re-attaching the
front panel

You can remove the front panel to protect your
unit from theft.
Press the open button and push the front panel
upward and pull it toward you.
For details, refer to operation manual.

Installation

2

Section

Installation

En

01

Advertising
This manual is related to the following products: