Pioneer VSX-818V-K - Manual (Page 59)

Other connections 10
59
En
English
Français
Deutsch
Nederlands
Italiano
Español
Important
If an error message lights in the display, try
following the points below:
Switching the iPod controls
1
You can switch over the iPod controls between
the iPod and the receiver.
1 Press iPod CTRL to switch the iPod
controls. 2
This enables operation and display on your
iPod, and this receiver’s remote control and
OSD become inactive.
2 Press iPod CTRL again to switch back to
the receiver controls.
iPod® is a trademark of Apple Inc., registered in
the U.S. and other countries.
Connecting a USB device
It is possible to listen to two-channel audio
3
using the USB interface on the front of this
receiver. Connect a USB mass storage device
4
as shown below.
• Push down on the PUSH OPEN tab to
access the iPod DIRECT USB terminal.
Symptom What it means
Error I1 There is a problem with the signal path
from the iPod to the amplifier. Switch off
the amplifier and reconnect the iPod to
the amplifier. If this doesn’t seem to
work, try resetting your iPod.
Error I2 The software version being used with the
iPod needs to be updated. Update the
software being used with the iPod
(please use the latest iPod software
versions later than the iPod updater
2004-10-20).
Error I3 The iPod that is not supported is
connected. Check whether the iPod was
supported by this receiver (page 57).
When the iPod software version is too
old. Update the iPod software to the
latest version.
Error I4 When there is no response from the
iPod. Update the iPod software to the
latest version.
No Music
Track There are no playable songs currently
stored in the iPod. Input some music
files compatible with iPod playback.
No Track When there are no tracks in the category
selected on the iPod. Select a different
category.
Note
1 You cannot use this function, when an iPod of fifth generation or iPod nano of first generation is connected.
2 When this function is set, iPod images cannot be played on this receiver.
3 This includes playback of WMA/MP3/MPEG-4 AAC files (except files with copy-protection or restricted playback).
4 • Compatible USB devices include external magnetic hard drives, portable flash memory (particularly keydrives) and digital
audio players (MP3 players) of format FAT16/32. It is not possible to connect this unit to a personal computer for USB playback.
• Pioneer cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and assumes no
responsibility for any loss of data that may occur when connected to this receiver.
• With large amounts of data, it may take longer for the receiver to read the contents of a USB device.
MCACC
PORTABLE
iPod DIRECT
USB AUDIO R L VIDEO
MASTER
VOLUME
PUSH
OPEN
MCACC PORTABLE iPod DIRECT USB AUDIO R L VIDEO
This receiver
USB mass
storage device
VSX_918_818_MY.book 59 ページ ２００７年１２月２７日 木曜日 午後４時２７分