Pioneer VSX-818V-K - Manual (Page 70)

Additional information 12
70
En
Important information regarding
the HDMI connection
(VSX-918V model only)
There are cases where you may not be able to
route HDMI signals through this receiver (this
depends on the HDMI equipped component you
are connecting-check with the manufacturer for
HDMI compatibility information).
If you aren’t receiving HDMI signals properly
through this receiver (from your component),
please try the following configuration when
connecting up.
Configuration
1
Connect your HDMI-equipped component
directly to the display using an HDMI cable.
Then use the most convenient connection
(digital is recommended) for sending audio to
the receiver. See the operating instructions for
more on audio connections. Set the display
volume to minimum when using this
configuration.
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the ADVANCED
SURROUND button, press and hold the
STANDBY/ON button for about three
seconds.
3 When you see RESET? appear in the
display, press ‘ ST – ’.
OK? shows in the display.
4 Press SOUND RETRIEVER to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory settings.
Switching the speaker impedance
We recommend using speakers of 8 Ω with
this system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6
Ω impedance rating.
• With the receiver in standby, press
STANDBY/ON while holding down the
SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
speakers are rated at 6 Ω .
• SP 8 OHM – Use this setting if your
speakers are rated at 8 Ω or more.
Note
1 • If your display only has one HDMI terminal, you can only receive HDMI video from the connected component.
• Depending on the component, audio output may be limited to the number of channels available from the connected display
unit (for example audio output is reduced to 2 channels for a monitor with stereo audio limitations).
• If you want to switch the input source, you’ll have to switch functions on both the receiver and your display unit.
• Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the display every
time you switch input sources.
VSX_918_818_MY.book 70 ページ ２００７年１２月２７日 木曜日 午後４時２７分