Pioneer ANH-P9R-BK - Manual (Page 10)

Connecting the Units
En 10
Blue/white (7*)
To Auto-antenna relay control terminal
(max. 300 mA 12 V DC).
Blue/white (6*)
Note:
When a subwoofer is
connected to this unit
instead of a rear speaker,
change the rear output
setting in the Initial Setting.
(Refer to the Operation
Manual.)
The subwoofer output of this
unit is monaural.
System remote control
Front output (F)
Rear output or
subwoofer output (R)
The pin position of the ISO connector will differ depending
on the type of vehicle. Connect 6* and 7* when Pin 5 is an
antenna control type. In another type of vehicle, never
connect 6* and 7*.
Antenna jack
Refer to Power cable
connection on page 8.
IP-BUS input (Blue)
Refer to System
connection on page 12.
This Product
GPS aerial jack
Refer to Power cable
connection on page 8.
Connecting to separately sold power amp
• In the case an auto antenna is installed, either turn off
the ignition switch or detach the front panel to put
away the antenna.