Pioneer DEH-P6700MP - Manual (Page 41)

2 Press a or b to turn WARN on or off.
Pressing a or b will turn WARN on or off and
that status will be displayed (e.g.,
WARN :ON).
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press FUNCTION to select AUX.
Press FUNCTION repeatedly until AUX ap-
pears in the display.
2 Press a or b to turn AUX on or off.
Pressing a or b will turn AUX on or off and
that status will be displayed (e.g.,
AUX :ON).
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put) can be used for full-range speaker
(R-SP : FUL) or subwoofer (R-SP : S/W) con-
nection. If you switch the rear output setting
to the R-SP : S/W, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (R-SP : FUL). When rear output
is connected to full range speakers (when
R-SP : FUL is selected), you can connect the
RCA subwoofer output to a subwoofer. In this
case, you can select whether to use the sub-
woofer controllers (low pass filter, phase)
built-in P/O:S/W or the auxiliary P/O:FUL.
1 Press FUNCTION to select R-SP.
Press FUNCTION repeatedly until R-SP ap-
pears in the display.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
R-SP : FUL (full-range speaker) and R-SP : S/W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select R-SP : FUL.
# When a subwoofer is connected to the rear
output, set for subwoofer R-SP : S/W.
# When the rear output setting is R-SP : S/W,
you cannot change the subwoofer controller.
3 Press c or d to switch the subwoofer
output or non fading output.
Pressing c or d will switch between P/O:S/W
and P/O:FUL and that status will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page 38)
or subwoofer output (refer to Using subwoofer
output on page 37) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
Initial Settings
En
41
English
Section
10