03 listening to your system, Auto listening mode, Listening in surround sound – Pioneer DCS-370 User Manual
Page 14: Using extra power mode, Listening to your system, Listening to your system 03, Chapter 3
Listening to your system
03
14
En
Chapter 3
Listening to your system
Auto listening mode
The Auto listening mode is the simplest way to
listen to any source as it was mastered: the
output from the speakers mirrors the channels
in the source material.
•
Press SURROUND to select the AUTO
listening mode.
1
Listening in surround sound
You can listen to stereo or multichannel
sources in surround sound.
2
Surround sound
is generated from stereo sources using one of
the Dolby Pro Logic decoding modes.
•
Press SURROUND repeatedly to select a
listening mode.
1
The choices that appear in the display will vary
according to the type of source that’s playing.
•
AUTO – Auto listening mode (see above)
•
DOLBY PL (Dolby Pro Logic) – 4.1 channel
surround sound (use with any two-channel
source)
•
MOVIE (Dolby Pro Logic II Movie) – Pro
Logic II 5.1 channel surround sound,
especially suited to movie sources (use
with any two-channel source)
•
MUSIC (Dolby Pro Logic II Music) – Pro
Logic II 5.1 channel surround sound,
especially suited to music sources (use
with any two-channel source)
•
STEREO – See Listening in stereo below
Using Extra Power mode
Extra Power mode allows you to enjoy richer,
fuller sound from stereo (2.1ch) sources.
3
Extra
Power mode is available when listening to
DVD/CD or USB sources.
•
Press EXTRA PWR to select MODE ON or
MODE OFF.
4
After selecting
MODE ON, the F.SURR.
indicator lights on the front panel display.
Note
1 If the source is Dolby Digital or DTS, the corresponding indicator lights in the front panel display.
2 Note that the input source must be switched to
DVD/CD or USB for multichannel playback.
3 When the Extra Power mode is on, most sound features cannot be used. The display will briefly blink
EXTRAPWR if you try and
use a prohibited function while the Extra Power mode is on.
4 • Note that you cannot use Extra Power mode when using headphones. If you press
EXTRA PWR when headphones are
connected, a ’CANNOT’ error message appears on the front panel display.
• When set to
MODE ON, make sure to follow the Setup Guide for best surround sound.
• When set to
MODE OFF, the listening mode is automatically set to AUTO.
DCS-363.book 14 ページ ２００７年１月１６日 火曜日 午前１１時５５分