Pioneer DDJ-SR - Manual (Page 28)

En 28
Changing the settings
Setting the default value of the beat for
the hot cue roll function
To use the hot cue roll function, set the default number of beats to be
repeated.
! By default, this is set to 1/4.
1 Launch utilities mode 2, then press the left deck’s
[HOT CUE] mode button.
The currently set number of beats is displayed on the beat indicator.
2 Press the left deck’s [PARAMETERc] or
[PARAMETERd] button.
The setting value changes each time the [PARAMETERc] or
[PARAMETERd] button is pressed.
1/32
n1/16n1/8n1/4n1/2n1
Setting the default value of the Combo
FX level
Set the default value of the effect parameter (level/depth) for the Combo
FX function.
! By default, the effect level parameters are set as shown below.
Level
100
Level
100
Level
100
Level
100
Level
100
Level
100
! Different setting values can be set for the respective pads, but the
left and right performance pads are set to the same values.
! These settings cannot be used for pads 4 and 8.
1 Launch utilities mode 2, then press the right deck’s
[HOT CUE] mode button.
2 Press the performance pad you want to set.
The pad that was pressed lights and the currently set level is indicated
on the level indicator.
Level 12 Level 50 Level 75 Level 100
3 Press the right deck’s [PARAMETERc] or
[PARAMETERd] button.
The setting value changes each time the [PARAMETERc] or
[PARAMETERd] button is pressed.
Level 12
nLevel 50nLevel 75nLevel 100
Setting the default value of the Combo
FX filter operation mode
Set the default value of the effect parameter (filter operation mode) for
the Combo FX function.
! By default, the filter operation mode parameters are set as shown
below.
Slow Slow Slow
Quick Quick Quick
! Different setting values can be set for the respective pads, but the
left and right performance pads are set to the same values.
! These settings cannot be used for pads 4 and 8.
1 Launch utilities mode 2, then press the right deck’s
[ROLL] mode button.
2 Press the performance pad you want to set.
The pad that was pressed lights and the currently set value is indicated
on the level indicator.
Off Slow Quick LFO
3 Press the right deck’s [PARAMETERc] or
[PARAMETERd] button.
The setting value changes each time the [PARAMETERc] or
[PARAMETERd] button is pressed.
Off
nSlownQuicknLFO
! Off: The filter effect is disabled.
! Slow: The high pass filter (HPF) effect gradually gets stronger
while the pad is being pressed.
! Quick: The high pass filter (HPF) effect is applied quickly the
moment the pad is pressed.
! LFO: The high pass filter (HPF) and low pass filter (LPF) effects
are applied alternately while the pad is being pressed.
Setting the default value of the beat for
the sampler roll function
To use the sampler roll function, set the default number of beats to be
repeated.
! By default, this is set to 1/4.
1 Launch utilities mode 2, then press the left deck’s
[SAMPLER] mode button.
The currently set number of beats is displayed on the beat indicator.
2 Press the left deck’s [PARAMETERc] or
[PARAMETERd] button.
The setting value changes each time the [PARAMETERc] or
[PARAMETERd] button is pressed.
1/32
n1/16n1/8n1/4n1/2n1