Connecting to an antenna, Preparing the remote control unit, Inserting batteries cautions regarding batteries – Pioneer PDP-436RXE User Manual

Page 16: Preparation 05

Advertising
background image

16

En

Preparation

05

Connecting to an antenna

To enjoy a clearer picture, use an outdoor antenna. The
following is a brief explanation of the types of connections that
are used for a coaxial cable.

Antenna cable (commercially available)

NOTE

• If the antenna is not connected correctly, the quality of

reception may be impaired. If images are not displaying
correctly, check whether the antenna connection is correct
or not.

Preparing the remote control unit

Inserting batteries
1

Open the battery cover.

2

Load the supplied two AA size batteries while inserting
their respective negative polarity (–) ends first.

• Place batteries with their terminals corresponding to the

(+) and (–) indicators in the battery compartment.

3

Close the battery cover.

Cautions regarding batteries

Improper use of batteries can result in chemical leakage or
explosion. Be sure to follow the instructions below.

• When you replace the batteries, use manganese or alkaline

ones.

• Place the batteries with their terminals corresponding to the

(+) and (–) indicators.

• Do not mix batteries of different types. Different types of

batteries have different characteristics.

• Do not mix old and new batteries. Mixing old and new

batteries can shorten the life of new batteries or cause
chemical leakage in old batteries.

• Remove batteries as soon as they have worn out. Chemicals

that leak from batteries can cause a rash. If you find any
chemical leakage, wipe thoroughly with a cloth.

• The batteries supplied with this product may have a shorter

life expectancy due to storage conditions.

• If you will not use the remote control unit for an extended

period of time, remove the batteries from it.

CAUTION

• WHEN DISPOSING OF USED BATTERIES, PLEASE

COMPLY WITH GOVERNMENTAL REGULATIONS OR
ENVIRONMENTAL PUBLIC INSTRUCTION’S RULES
THAT APPLY IN YOUR COUNTRY/AREA.

• Connect the 75-ohm coaxial cable (commercially available) to the

ANT

(antenna input) terminal.

If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the Plasma Display.

PDP-436RXE.book Page 16 Thursday, September 29, 2005 10:37 AM

Advertising