Pioneer AVH-P4200DVD - Manual (Page 56)

1 Display the DSP function menu.
Refer to Introduction of menu operations on
page 46.
2 Touch Time Alignment and then touch
Adjustment.
# Adjustment can only be selected when either
Front-L or Front-R is selected in Position.
3 Touch a or b to select the speaker to
be adjusted.
Front-L (left front speaker)
—Center (center
speaker)
—Front-R (right front speaker)—
Rear-R (right rear speaker)
—Rear-L (left rear
speaker)
—Subwoofer (subwoofer)
# Speakers with the size set to Off cannot be se-
lected. (Refer to Setting the speaker setting on
page 53.)
4 Touch c or d to adjust the distance be-
tween the selected speaker and the listen-
ing position.
Range:
0.0cm to 500.0cm
Using the equalizer
You can adjust the equalization to match the
car
’s interior acoustic characteristics as de-
sired.
Recalling equalizer curves
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves.
Display Equalizer curve
Powerful Powerful
Natural Natural
Vocal Vocal
Flat Flat
Custom1 Custom 1
Custom2 Custom 2
Super Bass Super bass
! The equalizer curves for Custom1 and
Custom2 can be adjusted.
! When Flat, no changes are made to the
sound. You can check the effects of the
equalizer curves by switching alternatively
between
Flat and another equalizer curve.
! When Digital Direct is on, the equalizer
curve is fixed to Flat.
1 Display the DSP function menu.
Refer to Introduction of menu operations on
page 46.
2 Touch Parametric EQ.
3 Touch a or b to select the EQ(equali-
zer).
4 Touch d to select the equalizer.
Powerful
—Natural—Vocal—Flat—Custom1
—Custom2—Super Bass
Adjusting the 3-band parametric
equalizer
For Custom1 and Custom2 equalizer curves,
you can adjust the front, rear and center
equalizer curves separately by selecting a cen-
ter frequency, an equalizer level and a Q factor
for each band.
! A separate Custom1 curve can be created
for each source.
! A Custom2 curve that is common for all
sources can be created.
! The center speaker largely determines the
sound image and getting the balance right
is not easy. We recommend that you first
adjust the balance among all of the speak-
ers except the center speaker, by playing 2-
channel audio (a CD, for example). Then,
play 5.1-channel audio (Dolby Digital or
DTS) and adjust the center speaker output
to match the balance already created
among the other speakers.
1 Display the DSP function menu.
Refer to Introduction of menu operations on
page 46.
En
56
Section
13 Menu operations