Pioneer AVH-P4200DVD - Manual (Page 68)

! Ground – When the polarity of the con-
nected lead is negative while the gear shift
is in REVERSE (R) position
! Off – When a rear view camera is not con-
nected to this unit
Selecting the video format
You can switch the video output format of V
OUT between NTSC and PAL.
1 Display the system menu.
Refer to Introduction of menu operations on
page 46.
2 Touch Video Output Format on the sys-
tem menu to select the video output for-
mat.
NTSC
—PAL
Note
You can switch the video output format only for
the source from this unit.
Setting the TV signal
When you connect this unit to a TV tuner, be
sure to adjust the TV signal setting to one that
is suitable for your country.
! As this function is initially set to Auto, the
unit will automatically adjust the TV signal
setting.
However, the screen may turn black or
images may not be displayed properly
when
Auto has been selected and the re-
ception is weak. Normally, select the appro-
priate TV signal.
! About your country TV signal, consult with
your nearest Pioneer dealer.
! Only when a Pioneer TV tuner (e.g. GEX-
P5700TVP) is connected to this unit, you
can operate this function.
1 Display the system menu.
Refer to Introduction of menu operations on
page 46.
2 Touch TV Signal on the system menu to
select the appropriate TV signal.
Auto
—PAL—SECAM
Selecting the area group
1 Select the TV source.
Refer to Basic Operations on page 10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 46.
3 Touch TV Country Group on the func-
tion menu.
4 Touch c or d until the desired area
group appears.
Country1 (CCIR channel)
—Country2 (Italy
channel)
—Country3 (U.K. channel)—
Country4 (OIRT channel)
Auto EQ (auto-equalizing)
The auto-equalizer automatically measures
the car
’s interior acoustic characteristics, and
then creates an auto-equalizer curve based on
that information.
WARNING
As a loud tone (noise) may be emitted from the
speakers when measuring the car's interior
acoustic characteristics, never perform auto TA
or auto EQ while driving.
CAUTION
! Thoroughly check the conditions before per-
forming auto EQ as the speakers may be da-
maged if these functions are performed when:
— The speakers are incorrectly connected.
(For example, when a rear speaker is con-
nected as a subwoofer output.)
— A speaker is connected to a power amp de-
livering output higher than the speaker
’s
maximum input power capability.
En
68
Section
13 Menu operations