Pioneer AVH-P4000DVD - Manual (Page 42)

Switching the auxiliary 1 setting
% Touch AUX1 on the initial menu to se-
lect desired setting.
! VIDEO – an iPod with video capabilities
connected with 4-pole mini plug cable (e.g.,
CD-V150M)
! AUDIO – auxiliary device connected with
stereo mini plug cable
! OFF – No auxiliary device is connected
Switching the auxiliary 2 setting
% Touch AUX2 on the initial menu to turn
auxiliary 2 setting on.
# To turn auxiliary 2 setting off, touch AUX2
again.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
FULL) or subwoofer (S.W) con-
nection. If you switch the rear output setting
to
S.W, you can connect a rear speaker lead
directly to a subwoofer without using an auxili-
ary amp.
Initially, the unit is set for rear full-range speak-
er connection (
FULL). When rear output is
connected to full range speakers (when FULL
is selected), you can connect other full range
speakers (
REAR) or a subwoofer (S.W) to the
RCA rear output.
! When the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you
cannot operate this function.
1 Touch REAR SP on the initial menu.
2 Touch c or d next to REAR SP to switch
the rear output setting.
Touch c to select full-range speaker and FULL
appears in the display. Touch d to select sub-
woofer and
S.W appears in the display.
# When no subwoofer is connected to the rear
output, select
FULL (full-range speaker).
# When a subwoofer is connected to the rear
output, select
S.W (subwoofer).
# When the rear output setting is S.W, you can-
not operate the following procedure.
3 Touch c or d next to PREOUT to switch
the subwoofer output or rear output.
Touching c or d will switch between S.W and
REAR and that status will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
36).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
% Touch FM STEP on the initial menu to
select the FM tuning step.
Touching
FM STEP will switch the FM tuning
step between 50 kHz and 100 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Note
The tuning step remains at 50 kHz during manual
tuning.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
% Touch AUTO PI to turn Auto PI Seek on.
# To turn Auto PI Seek off, touch AUTO PI
again.
Operating this unit
En
42
Section
03