External monitor – Toshiba PORTEGE R700 User Manual
Page 73
8.
Grasp the module by its edges and remove it from the computer.
If you use the computer for a long time, the memory modules and the
circuits locating close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them. Or
you will get burnt if you touch any of them.
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
Figure3-11Removing the memory module
1
1
1.
Latches
9.
Seat the memory module cover in place and secure it with the screws.
Take care to ensure that the memory module cover is firmly closed.
10. Install the battery pack - refer to
section in
chapter 6, Power and Power-Up Modes, if required.
11. Turn your computer over.
External monitor
An external analog monitor can be connected to the external monitor port
on the computer. To connect a monitor, follow the steps as detailed below:
There are no fastening screws for an external monitor cable on this
computer's external monitor port. However, external monitor cables which
have connectors with fastening screws can still be used.
PORTÉGÉ R700 / Satellite R630
3-28
User's Manual