Bowflex Ultimate - Manual (Page 100)

A-12
Assembling Your Bowflex
®
Ultimate
™
Lat Assembly
Figure P
50
54
57
19
20 40
54
17
Step 1: LAT TOWER ASSEMBLY
Locate the following parts for this step:
• Lat cross bar w/ pulleys (Item #17)
• Upper lat tower (Item #19)
• Two (2) 3/8”X2-3/4” bolts (Item #50)
• Four (4) 3/8” washers (Item #54)
• Two (2) 3/8” nylon lock nuts (Item #57)
• Strap hook (Item #20)
• Two (2) 1/4”X5/8” phillips head screws (Item #40)
Attach the lat cross bar assembly (Item #17) to the upper lat
tower (Item #19) with two (2) 3/8”X2-3/4” bolts (Item #50),
four (4) 3/8” washers (Item #54) and two (2) 3/8” nylon lock
nuts (Item #57) as shown in Figure P.
Attach the strap hook (Item #20) to the rear of the upper
lat tower using two (2) 1/4”X5/8” phillips head screws
(Item #40) also shown in Figure P. Make sure the strap
hook loop faces downward as shown in the inset.
Note: Take care to securely tighten the lat cross bar to
the upper lat tower.
Strap Hook
Unit appears
like this
following this
assembly step
Components for this step are in
the Lat Attachment Box
Figure Q
Step 2: LAT TOWER INSTALLATION
Note: It is recommended that
two people be used to accomplish
this step. Take care to insure the
upper lat assembly is properly
and securely attached to the
base assembly.
Locate the following parts for this step:
• Six (6) 3/8”X3/4” bolts (Item #46)
• Six (6) 3/8” washers (Item #54)
• Upper lat tower assembly (from Step 9)
Assemble the upper lat tower
assembly to the base unit using six (6)
3/8”X3/4” bolts (Item #46) and six (6)
3/8” washers (Item #54) as shown in
Figure Q.
* Remove and discard the foam plug
from the lat tower cable storage hole.
Unit appears like
this following this
assembly step
*Foam Plug
Please go to Step 10 on Page 11
to finish assembly.