Bowflex Ultimate - Manual (Page 104)

A-16
ASSEMBLING YOUR Bowflex ® T-BAR
Your T-bar was shipped fully assembled with the metal bar
resting in the loops of the nylon strap. If, however, the bar
and the nylon strap separated during shipping, follow these
instructions for reassembly.
The nylon strap has one flat side and one side with several
twists. Lay the nylon strap on a flat surface with the flat
side down, as shown in Figure W.
Lift the strap by the metal rings and hold it in front of you.
Turn the strap completely over with the twisted side down.
Grab the strap in the center with the index finger of one
hand. See Figure X.
Use your index finger and thumb of your free hand to
spread the strap into two loops, as shown in Figure Y
Using your free hand, slide the bar through the loops.
Remove your fingers from the loop. The strap should wrap
around the bar evenly and slide loosely and freely around
the bar. See figure Z.
Assembling Your Bowflex
®
Ultimate
™
Leg Assembly
Step 5: INSTALLING THE LEG EXTENSION ATTACHMENT
Place the leg extension on the end of the rail and tighten the two
small star knobs (Item #68) through the sides of the leg extension rail
bracket and into the rail as shown in Figure V. Make sure that the leg
extension does not interfere with the rear leg, and if it does interfere,
check to make sure the rear leg is mounted 1/2” to 1” from the end of
the seat rail.
Take the leg attachment cables and snap them into the cable storage
clips on the bracket under the seat rail.
Figure V
68
BEFORE EACH USE OF THE
EQUIPMENT, CHECK ALL
FASTENERS, SNAP HOOKS,
CABLES AND PULLEY
FUNCTIONS. TIGHTEN AND
FASTEN AS NEEDED. CHECK
PULLEYS AND CABLES FOR
WEAR AND FUNCTION.
Unit appears like
this following this
assembly step
(shown with
optional lat
tower)
Figure W Figure X
Figure Y Figure Z