Sharp MX-2614N - Manual (Page 74)

1-33
BEFORE USING THE MACHINE
Contents
CHANGING THE PAPER SIZE IN PAPER TRAY 3 - TRAY 4
To change the paper size of tray 3 - tray 4, follow the steps below.
This section only explains how to change the paper size. For the procedures for opening/closing the tray and loading
paper, see "
LOADING PAPER IN PAPER TRAY 3 - TRAY 4 " (page 1-32).
4
Gently push tray 3-tray 4 into the
machine.
Push the tray firmly all the way into the machine.
5
Set the paper type.
If the paper size was changed from an AB size to an inch size, or from an inch size to an AB size, or if the paper type was
changed, be sure to change the appropriate settings as explained in "
Paper Tray Settings " (page 7-13) in the System
Settings.
6
Loading paper in paper tray 3/tray 4 is now complete.
1
Remove the paper size guide.
With the base of the tray pressed all the way down, hold down
the hook at the bottom on the paper size guide and pull the
paper size guide up slightly.
• Do not place heavy objects on the tray or press down on the tray.
• Before changing the paper size of tray 1, raise the paper guide.
2
Adjust the paper size guide to the paper
size to be used.
Paper sizes are inscribed at the slot (A) on the bottom of the
tray and at the hole (B) at the top of the paper size guide. ("LT"
indicates 8-1/2" x 11" size.)
Align the bottom of the paper size guide with the slot, and align
the hole at the top with the locking tab.
• When attaching the paper size guide, make sure that the top and bottom of the guide are aligned to the same paper
size.
• If the top and bottom of the paper size guide are not aligned to the same paper size, skewed feeding and misfeeds
will result.
Hook
Tray 3 Tray 4
Paper guide
A4
LT
LT
A4
(A)
(B)