Sharp MX-2614N - Manual (Page 784)

7-116
SYSTEM SETTINGS
Contents
Settings for fax reception can be configured.
Number of Calls in Auto Reception
This setting is used to select the number of rings on
which the machine automatically receives a call and
begins fax reception in auto reception mode.
The "Number of Calls in Auto Reception" that can be set
in each country are shown in the following table.
Country Differentiation Table
Switching from Manual to
Automatic Reception
This setting can only be activated in France.
When a fax is received in manual reception mode, you
have have the machine automatically switch to auto
reception. The number of rings on which switching to auto
reception takes place can be set to any number from 1 to 9.
Duplex Reception Setting
This is used to have received faxes printed on both sides
of the paper.
When this setting is enabled and a fax consisting of 2 or
more pages is received (the pages must be the same
size), the pages are printed on both sides of the paper.
Auto Receive Reduce Setting
When a fax is received that includes the sender's name
and number, the received image is slightly larger than
the standard size. This setting is used to automatically
reduce the image to fit the standard size.
Print Style Setting
This setting determines the paper selection condition
when printing received faxes. Select one of the three
conditions below.
Print Actual Size Cut off Disabled
The received fax image is printed at full size without
dividing it onto multiple sheets of paper. If the same size
of paper or larger paper is not loaded, the fax will be
received in memory and will not be printed until a
suitable size of paper is loaded.
However, if the received fax is longer than A3 (11" x 17")
size, it will be automatically divided onto multiple sheets
of paper.
Print Actual Size Cut off Enabled
Each received image is printed at full size. If necessary,
the image is divided onto multiple sheets of paper.
Auto Size Select
Each received image is printed at full size when
possible. When not possible, the image is automatically
reduced before printing.
Set the Telephone Number for Data
Forwarding
When a problem prevents the machine from printing a
received fax, the received fax can be forwarded to
another fax machine. This setting is used to program the
fax number of the destination fax machine. Only one
forwarding fax number can be programmed (maximum
of 64 digits).
To insert a pause between digits of the number, touch
the [-] key.
If you wish to specify an F-code confidential memory box
in the destination machine, touch the [/] key after
entering the fax number and enter the F-code
(sub-address and passcode).
Fax Receive Settings
The number of rings
United Kingdom, France,
Germany, Sweden, Italy, Spain,
Netherlands, Thailand, Hong Kong,
Saudi Arabia, South Africa,
Hungary, Czech Republic,
Slovakia, Poland, Greece, Russia,
Philippines, Indonesia 0 to 9
Australia, New Zealand 2 to 4
Singapore 0 to 3
Malaysia, India, Canada, Taiwan 0 to 15
If you select "0" for the number of rings, the machine
will immediately answer and begin fax reception
without ringing in auto reception mode.
• If Auto Receive Reduce is disabled, the edges of
the image outside the standard size will be cut off.
However, the image will be clearer because it will
be printed at the same size as the original.
• Standard sizes are sizes such as A4 and B5
(8-1/2" x 11" and 8-1/2" x 5-1/2").