Advantech TPC-1261H User Manual
Tpc-1261h, User manual
Advertising
Table of contents
Document Outline
- Contents
- Chapter 1 General Information
- Chapter 2 System Setup
- Chapter 3 System Engine
- Chapter 4 Software Configuration
- 4.1 VGA Driver Installation
- 4.2 Advantech COM Driver Install
- Figure 4.10: PCI_ICOM Setup
- Figure 4.11: PCI ICOM Installation - 1
- Figure 4.12: PCI ICOM Installation - 2
- Figure 4.13: Device Manager Screen
- Figure 4.14: Update Driver - 1
- Figure 4.15: Update Driver - 2
- Figure 4.16: Update Driver - 3
- Figure 4.17: Slave Bridge Installation Complete
- Figure 4.18: PCI-1602 Device Manager
- Figure 4.19: PCI Serial port Device Manager
- Figure 4.20: Update Driver - 1
- Figure 4.21: Update Driver - 2
- Figure 4.22: Update Driver - 3
- Figure 4.23: PCI-1602 Master Installation
- Figure 4.24: PCI Serial Port Installation - 1
- Figure 4.25: PCI Serial Port Installation - 2
- Figure 4.26: PCI Serial Port Installation - 3
- Figure 4.27: PCI Serial Port Installation - 4
- Figure 4.28: PCI Serial Port Installation - 5
- Figure 4.29: PCI Serial Port Installation - 6
- Figure 4.30: PCI Serial Port Installation - 7
- Figure 4.31: Installation Complete
- 4.3 Entertainment Encryption/Decryption Driver
- Chapter 5 Features in Windows XP Embedded
- Appendix A Serial Port Settings
- Appendix B Watchdog Timer Programming
- Appendix C Watchdog Timer Programming on WinCE
- Appendix D Accessory Kit Assembly Procedure
- Appendix E HDD Kit Assembly
- E.1 Ruggedized HDD Kit
- Figure E.1: Removing the HDD cover
- Figure E.2: Required Parts
- Figure E.3: Opening the Top
- Figure E.4: Fastening the bracket
- Figure E.5: Connectting the FPC with the HDD
- Figure E.6: Placing the HDD insulator on the HDD
- Figure E.7: Reverse side of the HDD holder
- Figure E.8: Fastening the HDD holder
- Figure E.9: Mounting the cushions - 1
- Figure E.10: Mounting the cushions - 2
- Figure E.11: Placing the HDD holder - 1
- Figure E.12: Placing the HDD holder - 2
- Figure E.13: Fastening the HDD holder
- E.2 Internal HDD Kit Assembly
- Figure E.14: Removing the HDD cover
- Figure E.15: Placing a screw into its rubber casing
- Figure E.16: Mounting the rubber casings
- Figure E.17: Connecting the FPC cable
- Figure E.18: Inserting the HDD
- Figure E.19: Laying in the HDD insulator
- Figure E.20: Placing the cover back into position
- Figure E.21: Re-fastening the cover - 1
- Figure E.22: Re-fastening the cover - 2
- Figure E.23: Fastening the PCI/104 bracket - 1
- Figure E.24: Fastening the PCI/104 bracket - 2
- E.1 Ruggedized HDD Kit
- Appendix F Touchscreen Installation & Configuration
- Appendix G Fuse Specifications