Removing the door panel, Note, Removing the intermediate panel – Neff U14M42N3GB User Manual
Page 21: Cleaning, Risk of injury, Fitting the intermediate panel, Fitting the door panel, Refit the appliance door, Cleaning the hook-in racks
21
Removing the door panel
Note: Before removing, make a note of which way round the
door panel is fitted, so that it is not refitted the wrong way
round.
1.
Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section: Removing
and installing the appliance door).
2.
Pull off the cover at the top of the appliance door. Press in
the tabs on the left and right using your fingers (fig.A).
3.
Lift the door panel slightly and pull it out (Fig. B).
Removing the intermediate panel
Lift the intermediate panel slightly and pull it out towards you.
Cleaning
Clean the door panel with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting the intermediate panel
Note: During installation, make sure that the lettering "top right"
is upside down at the bottom left.
Insert the intermediate panel towards the back as far as it will
go.
Fitting the door panel
1.
Insert the door panel at an angle towards the back into both
brackets as far as it will go. The smooth surface must face
outwards.
2.
Put the cover back in place and press on it until it clicks in
place.
3.
Refit the appliance door.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.
Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.
Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.
Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.
Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.
Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.
Insert the hook-in rack at the front as far as it will go and push
downwards (figure D).
%
$
$
%
D
D
&
'