Philips Escoba eléctrica - Manual (Page 11)

removing the roller brush
1 To remove the stick, press the stick release button on the lower
handle (1) and pull the stick upwards (2) (Fig. 6).
 Turn the sweeper base upside down, push the retainer release slide
in the direction of the arrow (1) and remove the retainer
(2) (Fig. 17).
 Slip the belt off the end of the roller brush (1) and lift the roller
brush out of the base (2) (Fig. 18).
 Remove fluff, hairs and other dirt from the roller brush and the
groove.
reinserting the roller brush
1 Slip the belt over the ribbed end of the roller brush. Insert the
other end of the roller brush into the slot opposite the
belt (Fig. 19).
 Insert the end of the roller brush with the belt into the other
slot. (Fig. 20)
Do not force the roller brush into the slot. Rotate the roller brush so
that the ridge on the side with the belt points upwards.
 Put the retainer back into the slot (1) and slide the release slide to
its original position (‘click’) (2) (Fig. 21).
If the roller brush is not properly inserted, you cannot move the release
slide to locked position.
Cleaning the wheels
1 Switch off the appliance.
 Place the sweeper base upside down.
 Insert a slotted screwdriver underneath one of the wheels. Rotate
the screwdriver to loosen the wheel and axle from the
groove (Fig. 22).
Do not place your hand on the wheel.
English 11