Philips AVENT Vigilabebés DECT - Manual (Page 9)

The POWER light on the charger lights up.
using the appliance
1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 10).
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
 Press and hold the on/off button 3 on the baby unit for  seconds. (Fig. 11)
The nightlight lights up briefly.
The display lights up and indicates the current room temperature.
The ON light lights up.
 Press and hold the on/off button 3 on the parent unit for  seconds. (Fig. 1)
The sound level lights light up blue briefly.
The display lights up and the battery symbol and the temperature indication appear on the
display.
The LINK light flashes red briefly and then starts to flash green while the parent unit tries to
establish connection with the baby unit.
The LINK light on the parent unit flashes green until connection has been established.
This takes up to 0 seconds. The LINK light on the parent unit then lights up
green continuously (Fig. 1).
If no link is established after 30 seconds, the LINK light on the parent unit flashes red, the
parent unit beeps from time to time and the message O appears on the display
of the parent unit.
 Place the baby unit at least 1 metre/ feet away from your baby (Fig. 1).
5 Position the parent unit within the operating range of the baby unit. Make sure it is at least
1 metre/ feet away from the baby unit (Fig. 15).
For more information on the operating range, see section ‘Operating range’ below.
operating range
The operating range of the baby monitor is 300 metres/900 feet in open air. Depending on the
surroundings and other disturbing factors, this range may be smaller. Indoors the operating range is
up to 50 metres/150 feet.
Dry materials Material thickness Loss of range
Wood, plaster, cardboard, glass
(without metal, wires or lead)
< 30cm/12in 0-10%
Brick, plywood < 30cm/12in 5-35%
Reinforced concrete < 30cm/12in 30-100%
Metal grilles or bars < 1cm /0.4in 90-100%
Metal or aluminium sheets < 1cm/0.4in 100%
For wet and moist materials, the range loss may be up to 100%.
Features
adjusting loudspeaker volume
1 Briefly press the volume + and – buttons on the baby unit until the desired loudspeaker
volume for the baby unit has been reached (Fig. 16).
,
,
,
,
,
,
,
,
,
EngliSh 9