Philips Robust Collection Blender - Manual (Page 8)

You can only place the blender jar on the motor unit when the handle
points to the right.
2 Put the plug in the wall socket.
using the blender
1 Put the ingredients in the blender jar.
2 Place the lid on the blender jar (Fig. 6).
Push the lid down firmly to close it.
3 Insert the measuring cup into the opening in the lid (Fig. 7).
4 Turn the speed selector to select a speed.
Do not let the appliance run for more than 3 minutes at a time. If you
have not finished processing after 3 minutes, switch off the appliance.
Let the appliance cool down for one minute before you let the
appliance run again.
5 Before you open the lid, set the speed selector to 0 to switch off
the appliance.
after using the blender
1 Unplug the appliance.
2 Remove the lid with the measuring cup from the blender jar.
3 Remove the blender jar from the motor unit.
4 Always clean the removable parts immediately after use.
tips
- Cut solid ingredients into smaller pieces before you put them in the
blender jar.
- Do not process a large quantity of solid ingredients at the same time.
In that case, process the ingredients in a series of small batches.
Measuring cup
You can use the measuring cup to measure ingredients.
EnglisH 8
cleaning
Always clean the removable parts immediately after use.
Avoid touching the blades. The blades are very sharp.
1 Unplug the appliance.
2 Disassemble all removable parts before you clean them. (Fig. 8)
3 Clean all removable parts in the dishwasher or in warm water with
some washing-up liquid.
All parts except the motor unit are dishwasher-proof.
4 Clean the motor unit with a moist cloth.
Never immerse the motor unit in water or any other liquid, nor rinse
it under the tap.
Do not use abrasive cleaning agents, scourers, alcohol etc. to clean the
motor unit.
Quick-cleaning the blender jar
1 Pour lukewarm water (500ml-700ml) and some washing-up liquid
into the blender jar.
2 Place the lid on the blender jar and insert the measuring cup into
the hole in the lid.
3 Plug in the appliance.
4 Put the blender jar on the motor unit.
5 Press the pulse button to switch on the appliance and hold it for a
few seconds.
6 Release the pulse button and unplug the appliance.
7 Remove the blender jar from the motor unit, take off the lid and
rinse the blender jar with clean water.